Board Build Notes
Current Version
1.0.072 - Product Launch
0.0.69 accepted as Launch Design
Changes and Modifications
(F3) Fuse replaced with 500ma fuse from the origional 1000ma fuse, trip current was to high with sustained draw exceding volatge regulator it is meant to protect.
Updates to Come
##.0.000 - Currently in Design Process
Additions
Complete Layer Ground
Changes and Modifications
Accessorie LED to white from orange
Previous Versions
0.0.069 - Release Candidate
Additions
Accessory LED Connection Exposed to Pin Header
Addition of Silkscreen Graphics
Placed QR Marker for Boards Tracking
Switches Replaced with SMT Jumpers to reduce cost on parts & increase reliability
Changes and Modifications
JP3 Added jump connection between 5v (-) Acc. & 5v (-) Reg.
LED connection polarity fixed
Zenner Diode Polarity Fixed
Swapping F1 from componenet 0805L100WR-Little Fuse -> PTS08056V050-Eaton
0.0.055 - Beta
Board Modification Required to Work
LED Diodes need to be Installed in Reverse
Zenner Diode Needs to be Installed in Reverse
Jumper from 5v (-) Acc. to 5v (-) Reg on board
Updated LEDs to 1206 size and non dual LED chips
Zenner Diode SMT Footprint Corrected to 0805 Footprint
Changes and Modifications
Change to larger LED as dual LED choosen was to small to hand place
Updated resistor values for LED Connection
0.0.031 - Alpha
Case Build Notes
A side project for when I get stuck and need to refresh my brain, this is a 3D printable part meant to happily hold the board in place and protect from the perils of falls, squishes, or shorts.